Search results
Results From The WOW.Com Content Network
Ten-codes, officially known as ten signals, are brevity codes used to represent common phrases in voice communication, particularly by law enforcement and in citizens band (CB) radio transmissions. The police version of ten-codes is officially known as the APCO Project 14 Aural Brevity Code. [1]
A police code is a brevity code, usually numerical or alphanumerical, used to transmit information between law enforcement over police radio systems in the United States. Examples of police codes include "10 codes" (such as 10-4 for "okay" or "acknowledged"—sometimes written X4 or X-4), signals, incident codes, response codes, or other status ...
Technically a radiotelephonic spelling alphabet, it goes by various names, including NATO spelling alphabet, ICAO phonetic alphabet and ICAO spelling alphabet. The ITU phonetic alphabet and figure code is a rarely used variant that differs in the code words for digits.
In the United States, response codes are used to describe a mode of response for an emergency unit responding to a call. They generally vary but often have three basic tiers: Code 3: Respond to the call using lights and sirens. Code 2: Respond to the call with emergency lights, but without sirens.
A Radio code is any code that is commonly used over a telecommunication system such as Morse code, brevity codes and procedure words .
One "S" difference should correspond to 6 dB at signal strength (2x voltage = 4x power). On VHF and UHF receivers used for weak signal communications, S9 often corresponds to 5 μV at the antenna terminal 50 ohms. Amateur radio (ham) operators may also use a signal strength of "20 to 60 over 9", or "+20 to +60 over 9."
Voice procedure communications are intended to maximize clarity of spoken communication and reduce errors in the verbal message by use of an accepted nomenclature. It consists of a signalling protocol such as the use of abbreviated codes like the CB radio ten-code, Q codes in amateur radio and aviation, police codes, etc., and jargon.
The term radioteletype is used to describe both the original radioteletype system, sometimes described as "Baudot", as well as the entire family of systems connecting two or more teleprinters or PCs using software to emulate teleprinters, over radio, regardless of alphabet, link system or modulation.
Z Code (like and X Code) is a set of operating signals used in CW, and RTTY radio communication.
The Q-code is a standardised collection of three-letter codes that each start with the letter "Q". It is an operating signal initially developed for commercial radiotelegraph communication and later adopted by other radio services, especially amateur radio.